Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to propagate eigrp default route
Please find attached topology and R2 configuration
But, the network 200.1.1.0 is propagated as /30 network.
Shouldn't it be advertised as /24?
please Advice.
Vish
Hi, I have a question about the summarization that has been designed in attached topology.Why can't I start addressing the area 9 with 10.64.66.0/24 (instead of 10.64.68.0/24). According to my instructor, if I used 10.64.66.0/24, the summary would ov...
hi, i went through the following document - http://www.cisco.com/c/en/us/support/docs/ip/enhanced-interior-gateway-routing-protocol-eigrp/8651-21.html#building I just wanna know whether longest prefix match is considered first over AD and metric or i...
hi i have following configuration in my switch ALS1(config)# ip dhcp snoopingALS1(config)# interface range fastethernet 0/7 - 12ALS1(config-if-range)# ip dhcp snooping trustALS1(config-if-range)# exitALS1(config)# interface range fastethernet 0/15 - ...
No need to apologise..
Actually, getting candidate default as /24 was one of my instructor's requirements.
So, I was wondering if I am doing anything wrong....
R1 -
Gateway of last resort is 12.6.25.130 to network 200.1.1.0 200.1.1.0/30 is subnetted, 1 subnetsD* 200.1.1.0 [90/20537600] via 12.6.25.130, 00:00:14, Serial0/0 12.0.0.0/8 is variably subnetted, 9 subnets, 6 masksD 12.6.26.0/23...
Hi Masoud,
I have "3700 Software (C3725-ADVENTERPRISEK9-M), Version 12.4(15)T7, RELEASE SOFTWARE (fc3)"
but, still I am getting classless default candidate
