Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
For ACS 5.x is it possible to export config/device lists on any 5.x and import into a later 5.y ACS version? Example: export configuration on ACS 5.x and import on a 5.8.
Thanks
Regards
Hi,
I have been looking at the ACS install guide, deployment section:
http://www.cisco.com/c/en/us/td/docs/net_mgmt/cisco_secure_access_control_system/5-8/installation/guide/csacs_book/csacs_deploy.html
Question:
Is it possible for one of the ACS in...
Hello all,I'm facing a problem on multi-interface servers where they reply on the default gateway output interface regardless of where the request packets are received but keeping the request destination IP address as the source.This of course is cre...
Hello everyone,I know there is a way to set load balance on etherchannels and its based on mac/ip source/dst addresses.But is there a way to set weights for different interfaces? Similar to EIGRP.This is for 3560x and 4500Thank youSent from Cisco Tec...
Hi all,Didn't know wether I should open a discussion here or on security but...I'm looking for smal business routers to be used in small branches and create site-to-site VPN's to a central location firewall (Checkpoint) with public IP's.Additional de...
Steve,Thanks very much. Looks exactly like what I was looking for. Never head of host models but will have a try.Didn't find information for Win 7 (where I want to test). Can I assume Win7 behavior is the same as Vista's?Thanks
Hi Lei,Thanks very much. The use of multiple static to the same destination is actually news for me very good one. Heard of Pfr but never used or tried it.Thanks very much I'm gonna have some fun
