Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community,
I have a question on BGP advertised routes. I have 2 routers peered together same AS 1 both advertising to the AS of 65000. When issuing the command "IP BGP neighbor x.x.x.x advertised-routes" :
Router 1 states:
*> 10.20.30.128/27 ...
All,With version 7.3 there is a feature for redundancy. How does this feature work? Does anyone know? Can it be use where it is not directly connected, but can be connected as a layer 2?
Hello,I am unable to see routes in the routing when distributing EIGRP routes into BGP. When doing a show ip bgp.. I do see the route listed, but not from the routing table. Attached is my network topology. How my lab is setup is that from DENTST Rou...
Hi,I would like to know if it is possible to shoot wireless to an area using 4 wireless bridge to will be connected like this bridge >> bridge >> bridge >> brdige ?
Thanks! I was able to fix it, I was not advertising 192.168.203.2 network into BGP. Once I added that network, I was able to see 10.168.192.X network in the routing table. Thanks for the help.
From the configuration you posted, when configuring top talkers, this reports all the top talkers by packet. The IP address entered in the configuration is a creteria.
why not create subinterfaces of your network on your router and configure VRF Forwarding?e.g. :int gi0/0.2 dot1q 2 nativeip address xxx.xxxip vrf forwarding ???
