Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,I had ASA 5510 and modul SSM-10.Could you tell me, I want to reset default factory (configuration)on SSM-10 Because I can't log in Trend Micro Content Security.Best Regard,
Dear All,Coul you find the problem, i had two router 1721,wic-1T and V.35.Then i connected router 1721 to 1721 by V.35(not lease line or vpn, it simple connect),and I use protocol eigrp 50 for routing.After I configure already in router , i can ping ...
Dear Ahmed,this problem you can change version on software VPN client, you can try this version : vpnclient-windows-5.0.00.0340 or vpnclient-win-msi-5.0.01.0600-k9.Last time i met this problem also,!!!Best Regards,Norung
Dear Sir,The command on switch don't have1- Bandwidth2- police 256000 256000 exceed-action drop3- service-policy output LIMIT-TRAFFICPlease kindly see in the message as below:Switch(config-pmap)#class LIMIT-TRAFFICclass map LIMIT-TRAFFIC not configur...
Dear Kishore,Thanks you for you support me!!!! The command as below that you showed me i think that it can support Cisco switch 3560 and Router cisco right?how about Cisco Switch 2960 some command it cannot support as below:Switch(config)#policy-map ...
