Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I'm trying to make an ACI nexus 9k run in NXOS mode but it keeps saying the image verification has failed and then boots the ACI image.
However the md5sum for the nxos image matches the cisco web site.
The switch is an N9K-C9372PX - any ideas?
(no...
Hi
We have been using an 1801 router for UK ADSL for a few years with no issues.
We are replacing it with an 866VAE-W-E-K9
however there is zero atm or dsl activity on the replacement router.
Ive attempted to port the config directly from the 180...
HiI have a fault where client pcs attached to HIPT phones (not cisco) cannot participate on the network if they are disconnected from the phone and then reconnected.Workstations that are left in situ dont experience the problem, however laptops do: b...
thanks for the response - no joy though I'm afraid.
loader > cmdline recoverymode=1
loader > cmdline init_system
loader > dir
bootflash::
aci-n9000-dk9.11.0.4g.bin auto-s diag_bootup disk_log.txt lost+found nxos.7.0.3.I4.2.bin mem_log.txt.o...
I have also tried this from loader mode without success
loader > boot nxos.7.0.3.I4.4.binBooting nxos.7.0.3.I4.4.binTrying diskboot Filesystem type is ext2fs, partition type 0x83Image valid
Image Signature Verification Failed.
Boot failed
Error 9: U...
hi
checking this document;
http://www.cisco.com/c/en/us/products/collateral/routers/800-series-routers/data_sheet_c78-693249.html
suggests that these routers wont support DSL over PPPoA analogue phone lines and only support it over isdn?
http://w...
Hi
interface E0 is administratively shut = unfortunately it made no difference.
Ive tried two devices out of the batch of routers we bought and the link light does not stop flashing. DSL refuses to sync up. Ive tried it on three known good circuits...
