Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 6 sites with WS-C3560CG-8TC-S switches and one with the newer WS-C3560CX-8TC-S. We need to implement BFD on all of them to sort out our routing. 3560CG's are running ipbase 15.0(2)SE8The 3560CX is running ipservices15.2(4)E2 I can issue all re...
I had to swap out an 887V router this week as it stopped working after 4 months on a vdsl connection. I have observed that the cd light on this faulty router flashes constantly even when there are no cables connected to it (except for power of course...
Hi All,We have 2 non-contiguous public subnets from the same ISP presented on a single routed connection. Behind this we have 2 ASA 5520's in routed mode, both have outside interfaces in the same public subnet and we have various devices NAT'ed behin...
No, if the main WAN fails at a remote site its L3 switch loses all OSPF routes.If the main WAN fails and I have a static default route on the L3 switch (pointing towards the C887) site to site traffic switches to the backup tunnel and all is well. Ho...
Hi, thank you for the responses. I'm going to do some more work on this next week. The issue we have is that internet access at remote sites goes through ASA at the main site and it doesn't work when we failover from primary WAN to backup ipsec tunne...
I too have started seeing this error today on the stack master. I swapped the transceivers onto the member switch and they are working ok so far. I'm running 150-2.EX3
