Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi There,
I am doing a fresh install with data import. My source cucm cluster is 11.5, my destination cucm cluster is 14. The hostnames, ip addresses, and domain name of the destination cluster are different from the source cluster
I am using the Tou...
Hi All,I have some issues with incoming fax. The voice phase is successful but the switchover to fax fails. When I call the fax number it rings, connects, gives one short beep then is silent throughout the call until I drop the call.ITSP SBC--> (SIP ...
Hi There,Please assist. I have the setup below and all inbound calls fail:CUCM -->(h323) Gateway --> (H323-to-SIP) SBC --> Softswitch The SBC sends an Invite and PRACK towards the Gateway; the gateway responds with a Ringing and OK (to the PRACK) but...
Hi There,Does Cisco support a Unity Connection 8.5 solution/design with the Single Inbox Feature (for Unified Messaging) configured with Exchange 2003, or does it support the Single Inbox feature on Exchange 2010 only? Thanks
Hi Nithin,
Thanks for the response. I came right on this - I had to reduce the export data files of the CUCM nodes to 5GB in order for it to work.
The issue was that my export data files for the CUCMs were too big. They were 12GB for each node. I fou...
