Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have issues on all of our 3650's, we are getting a lot of output discards. I believe there is bug that can produce discards that arent actually there.Port Align-Err FCS-Err Xmit-Err Rcv-Err UnderSize OutDiscardsGi1/0/1 ...
I have configured AnyConnect and the VPN connects etc, my question is, where does AnyConnect pull its routing table from and is it possible to add routes? Also, is it possible to change the default GW that it assigns to clients?
Hi, Is it possible to configure AnyConnect to auto authenticate using the logged on users credentials? so they don't have to enter their username/password at Windows login and then again to connect via AnyConnect? Thanks,Mark
Hi, I am new to Firepower. We have FMC and I have added both firewalls to it. From what I can see, I can only configure certain things using the Firepower module, the interface IP's etc, I had to configure on the ASA part of the firewall. My question...
Hi,We just bought the FirePOWER Management Center license. Do I have to register the license on my account in some way in order to download the VmWare image does anybody know? It says I do not have access to download it.
Yes, I think you are onto something there, mostly all of the workstations on our network are connected via Cisco phones which can only run at 100Mbps because we bought the cheaper phones and we do have 1g and 10gb uplinks. I have checked another 3650...
We don't have any support on these switches unfortunately, so I don't have access to any tools to check for bugs, unless there is a free tool? Below are the stats: policy-map AutoQos-4.0-Output-Policyclass AutoQos-4.0-Output-Priority-Queuepriority le...
