About ronniepaton

ronniepaton · 12-05-2007

hi,I have 2 878 routers that will be getting connected via a BT ESP8 4 wire circut, but the carrier detect led will not come on, I have checked with BT and they are saying that they can only see the TX of the routers at both sides.I have had to use a...

ronniepaton · 02-17-2011

the console is only to setup up the unit it is designed to have all the config done via the web.If you have access to your DHCP server you could enable the DHCP client on the switch so it gets it's IP from your server. Then you should be able to see ...

ronniepaton · 02-17-2011

Are any of the SGE2000 in Layer 3 mode you can find this out on the main screen option 4Also what is your normal IP address range?Thanks

ronniepaton · 02-17-2011

The only reason that the device does not allow you to configure the IP on a differnt vlan is that the VLAN is not configured on the switch.If you know the VLAN Id on your network use that one.I would not change the default VLAN ID as you might lose n...

ronniepaton · 02-17-2011

I have just had a thought, If you know the VLANS ID that have been configured on your network you could re-address the switch to be a part of that VLAN.To do this go to the main config menu, option 6 , option 1, option 1 then change the ip address of...

ronniepaton · 02-16-2011

That option is not in the system, what you could try is to do a backup of the config via TFTP you will then be able to see what IP you have.Another question is the system mode in layer 3 if it is you could try the IP address of your default gateway.

Member Since	‎08-15-2005 01:48 AM
Date Last Visited	‎08-18-2017 04:03 AM
Posts	10

User Statistics

User Activity

cisco 878 no carrier detect LED

Re: SGE2000 Management IP

Re: SGE2000 Management IP

Re: SGE2000 Management IP

Re: SGE2000 Management IP

Re: SGE2000 Management IP