Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiYou must have a v2 card, that does support clock source independent but like you said you have to you have to delete the channel-group and add it backSince the provider is giving you clock specify the below command on the router.Global confignetwor...
Lan,You cannot bundle a frame-relay and a E1 using multilink. IF you want to load balance the traffic between the two links you can use protocol base load balancing or policy base routing. I would suggest that you open a case with Cisco TAC and they...
HI LuisIf i understand you correctly, are you asking to bundle a E1 link and a 512 frame-relay link together in multilink? IF so you cannot do that.IF the new provider does not support frame-relay then you can take that config out and configure it fo...
HIwhich controller do you see the slips? 0/1/0 or 0/1/1?Slips are related to colcking issues.configure controller 0/1/1 as clock sourn internal.Since the 0/1/0 is the primary clock souce the 0/1/1 will be able to get the clocking form that and sync.R...
