Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me why I can't pass traffic to a trunked port on a Cisco 2960 or 3560 with this config running on an ASR920? I can pass untagged traffic....BDI1 but nothing for VLAN's 10,20 or 30. Standard switchport mode trunk config on the switch...
Hello,Forgive me if I am posting to the wrong location. This is my first post.I am going to be updating the IOS on our Cisco ASA 5520 from verion 7.0(8) to 8.2(5). I am also going to setup AnyConnect. Are there any major changes in the 2 IOS versi...
Hello all,I have a site which has been successfully running a multilink bundle of four T1 lines for about 6 months. The remote location is a C3825 router and the central location router is a C7206. I have access to both. A few weeks ago the multil...
Thank you, mlund, for putting me on the right track. This worked: interface GigabitEthernet0/0/5no ip addressmedia-type auto-selectnegotiation autoservice instance 1 ethernetencapsulation untaggedbridge-domain 1!service instance 10 ethernetencapsula...
Thank you both for being so very helpful. The telco sent a tester out today and did indeed find that the NIU needed to be replaced at the central location. At first he couldn't isolate the issue because he had just had his testing equipment serviced ...
