Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Tried to configure access to device through firewall by giving it a static NAT and ACL rule but no luck. The device also doesn't have internet access not sure what I have configured wrong. Please help
Saved:ASA Version 9.1(2) !hostname enable passwo...
I did these steps on a 2960x but get no captured packetsmonitor capture buffer MYBUFFER size 10000 max-size 15500 circularmonitor capture point ip cef CAP gi1/0/3 bothmonitor capture point associate CAP MYBUFFERmonitor capture point start CAPI get no...
Most of our remote locations are L2, but I need to enable L3 on them and put them all on different subnets. We have several remote locations and I was wondering can I use the same VLAN numbers at each location if they are on different subnets? For ex...
We have over 50 VLANS, one for each department and others for different type of traffic. The goal is to shrink this down to maybe 10 at each site. I'm just not sure how to decentralize the VLANs from the core out to the access/distribution layer.Each...
The switches are not trunked together so I didn't think they would need to be on the same VLAN. How will the switches even know its passing untagged traffic right?
