Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am configuring GRE over IPSEC tunnel vpn between CISCO ASR 1000x & Juniper SRX210. After configuring the tunnel is up from both end but not able to communicate between tunnel. Even can't ping tunnel IP from both side. I am attached the config f...
Hi,I am configured a new 1602 AP which has external antenna. But both 2.4 and 5 GHz antenna does not covered satisfactory area compare to other cisco AP. Can anyone please suggests how can I extend the signal.
I want to configure IPsec over GRE tunnel in CISCO891-K9 router. GRE tunnel is working fine but I can't configure IPSEC. I found that crypto isakmp or crypro ipsec command is not there. The show version of the CISCO891-K9 is:EFLWH-1#sh verCisco IOS S...
Hi Saurav, Thanks for your suggestion. But I found that the coverage area is not significantly increase after plugin antenna which is almost same without antenna. How can I check my external antenna is working or not. Thanks in advanced.Mahbub
Thanks. Its works. But in show version I found "License Level: advipservices Type: Default. No valid license found." Is there any problem in Licence level and what to do?
