Hello all, i got a Problem on a customer which is using a Failover ASA 5510 pair with SSM-CSC-10-K9 modules. The clients have to connect to a webserver where they are doing some calculations. If they prepare everything and want to calculate everything what takes a couple of time the session is after about 3 minutes timedout. My first idea was to set session specific timeouts which are a bit longer then the normal but this setting did not work I created a policy which did not work for me. Does somebody has a conclusion for me how to set connection specific timeout's? policy which did not work:       access-list global_mpc_1 line 1 extended permit tcp object-group NET_Group_RFC1918 object H_EXT_Xeditor eq http       class-map Xeditor         match access-list global_mpc_1       policy-map global_policy         class Xeditor           inspect http           set connection timeout embryonic 0:10:00 half-closed 0:10:00 idle 1:00:00 reset dcd 0:15:00 5 config: timeout xlate 3:00:00 timeout pat-xlate 0:00:30 timeout conn 1:00:00 half-closed 0:10:00 udp 0:02:00 icmp 0:00:02 timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00 timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00 timeout sip-provisional-media 0:02:00 uauth 0:05:00 absolute timeout tcp-proxy-reassembly 0:01:00 timeout floating-conn 0:00:00 policy-map global_policy class inspection_default   inspect h323 h225   inspect h323 ras   inspect rsh   inspect rtsp   inspect sqlnet   inspect skinny    inspect sunrpc   inspect xdmcp   inspect sip    inspect netbios   inspect tftp   inspect ip-options   inspect icmp   inspect icmp error   inspect ftp   inspect dns class global-class   csc fail-open   set connection timeout embryonic 0:10:00 idle 1:00:00 reset dcd 0:15:00 5 ... View more