Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a large number of sites using Cisco ASA5505 firewalls with the IPSEC (ikev1) client in a very standard setup (just the basic wizard driven config, split tunneling and RADIUS enable). These have always worked well and we never having any probl...
HiI have configured a Cat560 with mulitple vlans, intervlan routing and IP helpers to allow our DHCP server to issue different subnets from different scopes. On anything connected directly to the 3650 works as expected and can connect to both subnets...
HiI am possibly going to have to upgrade my UC520 from version 7.0 to get support for the new SPA phones. Before i do so I would like to take an image of the flash card, so that in the event of a problem i can go back to the original setup. Is there ...
HiI am running a UC520 (12.4(20)T2), CME7.0(0) and CUE 3.2.1.We have recently purchased an SPA508G but cant get it to register.I have added the phone loads from a software pack, but the device type doesnt appear as an option.When monitoring the termi...
HiWe have a UC520 with the basic auto attendant setup to present a welcome message 'press one for sales, two for technical support' etc, and this all works well. The problem i have is that there is no fall back extension/group that rings if the calle...
HiUnfortunately we never upgraded the system and didnt deploy the new SPA phones either. The limited flash on the system made it a bit difficult to upgrade (although apparently possible), so we decided against it.Dan
HiSetting the ports to VLAN10 Untagged PVID sorted it.I think i was over complicating things by trying to have VLAN1 Untag and VLAN10 Tag, when all I needed was VLAN 10 on the access port in question.Thanks for your help.Dan
Hi PaulI have tried with and without the switchport mode trunk setting. Show Int Trunk does report it as a trunked connection with all VLANs enabled. But still no joy.If i change the port to Switchport Mode Access and set the VLAN to 10, then I can ...
HiThe config posted by Steven works!Just setup the exchange UM to support your dial plan, enable the users and set their extensions...Apparently the WMI doesnt work.Dan
