Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey mates,
How long it is needed to wait till the RRM has settled down in order to perform a relevant Wireless Sites Survey?Assuming that we would be bringing up 400 APs at the same time.
Regards
Hi colleagues,
The drop-down menu used for creating campus, buildings & floor within MAPS > Site MAPS does not appear whenever I am at the Floor View or the Outdoor View and the outcome is that I am not able to place APs inside de Map.
Cisco Prime I...
Hi Cisco Gurus,
I am just getting crazy trying to move a Campus I created on "Site Maps" from the Unassigned Campus. I would like to put it just below the root.
I already tried to remove it and create it back from scratch, but when I create an outdo...
Hi Guys,
Quick one:
In the following link http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#pgfId-149658 there is not table for 7.0.x-8.1.x.
Does it mean there is not any kind of compatibility between those...
Hi,I have got an RDSI movile link connected to a Cisco 2901 BRI interface. Every now and again the router shows me the port as layer1 down (not connected), although it is in deed.The issue does not get resolved till I connect the RDSI movile link to ...
Hi Kyle,
Yep! This is what I usually do, to force the RRM to re-calibrate... and wait till it finish. You can check the RRM events to be sure it has just finished.
But the question is whether there is specific recommendation from Cisco about the ti...
I ask, I do answer my self :).
It's all about how PRIME visualization is built-up.
Whenever you create a new Campus it just gets align (top-down view) with the other default campuses (unassigned and system campus).
But when you create a either a new...
