Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco guys,This is kind of a requiest I'm going to make to increase the ease of use of show command.I've seen some platform from other vendors that they use the "show" command to bring up the configuration under the sub-menu you are in.For an exam...
Hi All,We are having a Cisco 6500 with a Sup720 and running IOS 12.2(33)SXH6.In switch log we see a below log which has continuousely appeared from few weeks back:%HA_EM-6-LOG: Mandatory.go_unusedportlpbk.tcl: GOLD EEM TCL policy for TestUnusedPortLo...
I've got a question on the physical topology of a two pairs of clustered firewalls. Pls see the image below.Gi0/1 of VPN Firewalls and Gi0/0 of Firewall Cluster are connected directly. Is this a good physical topology to configure a cluster ? What pr...
Hi Geniuses,I have a requirement to track reachability of an interface with ip sla. i used the following configuration:I'm going to use this to put a reliable static route.I want to remove the route after 3 pings failed to the destination IP 10.1.1.1...
Hi,We have two 6500s located in two sites. We have purchased a 2Mbps site-to-site L2 circuit(ethernet) from a service provider beween these two sites. We have connected the ends of this 2Mbps link to the 6500s.We are carring multiple vlans on this L2...
Thank for the link jerry.After going through several documents of several switches now i'm getting the feeling that no cisco switch supports shapping on "switch ports". Does anybody can comment on this?
correct. but with following configuration we can use it in E3.controller sonet 3/0/0 framing sdh aug mapping au-4 au-4 1 aug-3 1 mode {c-12 | e3 }!If you specify the mode as c-12, you can configure E1s. If you specify the mode as e3, you can configu...
