Hi Can you please once try with mozilla firefox also. Because I succesfully updated my CISCO WAP 321 to 1.0.4.2. Try to re download the software in .tar and do it again. Please let me know what happened and can you please provide me the screen shot.. Thank you Punith Kumar Neelam ... View more

Hi Peter As Luis Arias metioned go to the link Captive Portal Instance Configuration on WAP321 Access Point After configuring instance you can desgin the web portal page in such a way all guest users can self register for the first time. For the configuration of the we portal page. Go to the following link Web Customization in Captive Portal on WAP321 Access Points For any question contact me back.. Thanks Punith Kumar Neelam Please rate the useful posts. ... View more

Hi Harvey Can you please provide the information about switch you are using.. Thanks Punith Kumar Neelam ... View more

Hi Rune I think the follwing will help you for configuring 802.1X . If you any future questions please contact me. Configuration of 802.1X Authentication on WAP121 and WAP321 Access Points Thanks Punith Kumar Neelam Please rate the useful posts. ... View more

Hi Greg I think if you are using native stacking you can use normal stacking if it is more than 4 also. In the release note you mentioned in your post is about basic hybrid not for the native. Thanks Punith Kumar Neelam ... View more

Hi Marisa You will get but from the third party not from the cisco. Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi Toupheng May I know the device you are using so that it will easy to guide you Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi Daniel I am sorry I didnt get much chance to work on them. But you can refer to the data sheets of those switches they will provide how the ports are designed. Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi Scott In case of DHCP failure this by using this static IP you can log into device and you can troubleshoot the device, that's why the static IP is not editable field and this IP will be your device IP or management IP. Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi Steenbroberg There is nothing like that, all the ports from port 1 to 24 has the same performance after the reset or without any manual configuration on the ports. In order know more about ports on the device you can refer the data sheet of SG300 series switches. To configure the Port settings refer to the following link: Configure Port Settings on 200/300 Series Managed Switches Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi Siming Sometimes even due to power cables LEDs wont on but system will work. Check with different power cable and if possible check the system logs. To configure the Green Ethernet and more information about Green Ethernet the following link will be helpful: http://sbkb.cisco.com/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=929 The following link will help you to understand  more about the system logs: http://sbkb.cisco.com/CiscoSB/Loginr.aspx?login=1&pid=2&app=search&vw=1&articleid=95 Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more

Hi I think the following link will be helpful to upgrade and after upgrading the firmware, reboot the switch to factory default settings. I tried and I was successful, so I though it would be helpful to you. The following link will be useful while upgrading : http://sbkb.cisco.com/CiscoSB/Loginr.aspx?login=1&pid=4&app=search&vw=1&articleid=947 Thanks & Regards Punith Kumar Neelam SBCD Engineer ... View more