Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
ello, I need to test an IPSEC tunnel between two Cisco ASR routers. I do not have any source and destination subnets to put into my Crypto ACL yet as this is still a test environment. So, I plan to use the loopback on one end, and the LAN interface o...
Hi Follks,I am planning to procure a Metro E circuit between two locations. Some of the traffic that would be routed between these two locations need to be secure, and not mix with other traffic/VLANs. Can I have Layer 3 (mu VRFs) and Layer 2 traffic...
Hi Folks, I have 2 x Cisco 3504 Wireless controllers connected to switches. There are currently two ports active on the WLCs towards the switches (both on Active and Standby WLC). These ports are part of a LAG, and there is port channel configured on...
Hi, I have a 100M Internet circuit connecting to a Cisco ISR4331 router. We are planning to upgrade the circuit to 400M, and have multiple businesses use this circuit.Can I implement traffic shaping to limit certain businesses to use only 300M of ban...
Hi, I am trying to setup an IPSEC tunnel between a Cisco ISR4431 router and a checkpoint firewall. I ran into multiple issues, and needed help to validate the configs and logs on the cisco router. Attached is the router config for your reference. Sou...
Hi, YOu can find in the link below the complete list of SFPs (Multimode included) supported on Cisco 4000 series ISRs. https://www.cisco.com/c/en_in/products/routers/4000-series-integrated-services-routers-isr/relevant-interfaces-and-modules.html#sma...
Thanks George. You already answered my first query - We can use loopback to simulate traffic and test out the IPSEC tunnel. I just needed to know if the loopback on the other end is used for Tunnel termination, can I still have that loopback in my en...
Thanks George. So, does Crypto endpoint and peer mean the same? If yes, the ASR 2 has Looback configured as crypto endpoint for other existing tunnels. So, If I use the same loopback as "peer address" for ASR_LEFT, can I still use the crypto ACL like...
Thanks Joseph. I have used the "bandwidth percent" command under the class to assign bandwidth to each of these classses. Please let me know if this looks ok? ip access-list extended Labspermit ip 10.x.x.x 0.0.1.255 anypermit ip 10.x.x.x 0.0.0.31 any...
