Our basic architecture is that of two 1900 series routers, one running the primary Verizon MPLS T1 and the other connected with a backup LTE connection into the same MPLS cloud as our primary T1. We have recently implemented a NAC imple...
We have an environment with multiple 2811's, 1941's, and 2821 routers in hundreds of locations. Depending on the location's needs, the Serial card may be an MFT or DSU type VWIC or HWIC and may be in different slots. So that I ca...
I have the event applet configured below. I test by changing the controller time-slots to 1-15 instead of 1-24 in order to generate errors on my Serial0/1/0:0 interface. Errors are generated, but the eem applet does not match even though the errors...
We have two ASR 1002's going to 2 different WAN service providers, and two 7371 WAE load balanced by mask assignment. When we change the ACL (adding or removing lines) from our wccp redirect-list, the throughput on interfaces applied to the wccp serv...
I installed another Serial interface just to verify and the applet only returns the one with the IP address, which is exactly what I needed. I'm now trying to figure out how to get this output to be entered into my event tags that occur prior to an...
I shortened to the applet config below and it output the Serial interface correctly. Am I losing anything by doing it this way?event manager applet Serial_Get_multiple_ifevent noneaction 1.1 cli command "show ip int brief | inc ^Se|Mu"action 1.21 s...
Looks like it is working better in that it is not getting the errors on action 1.8, but when I run the event manager applet, I get a blank line, instead of output. Here is the debug from running the applet in your last post. Thanks again for the ...
Here is everything that my buffer caught. I can try to narrow the debug event manager all down to specific's If I'm missing something important above this:Jul 8 12:16:38 EDT: close tag is Jul 8 12:16:38 EDT: Popping tag off stackJul 8 12:16:38 ...
Thank you, I changed the applet config to exactly as you suggested as shown below, and I received the debug output below when manually executing. I have aaa turned off for testing. Thank you very much for you expertise on this.Jul 8 12:16:38 EDT:...
