Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon,I'm working with a company that wants to create a point-to-point network using Cisco 2600 series AP's. This will consist of the MAP AP being plugged into a 8 port switch thats unmanaged. They want to only allow 1 network on that switch...
I'm reaching out for some help because I've never seen this done before and the customer says it can be done.My customer has HP wireless AP's and a Cisco ASR 1002 that they want to setup web authentication on for the wireless clients. Is this possibl...
What would cause the ports to go bad in these types of switches? I'm currently having problems with ports going bad in switches that are not even 2yrs old. They were purchased directly from cisco, and we let smartnet relapse so right now we don't hav...
I have noticed when I've upgraded my WLC 2504 to 7.3.112.0, my 1142 upgraded but none of the bootloaders and mini IOS match. The 3502 upgrade but none of the bootloaders and mini IOS match either. How can I fix this problem? Any suggestions? Should I...
Love the article but technically it did't help me at all. I completely understand about the vlans and making sure everything is labeled correctly. My issue I'm running into is the unmanaged switch that the customer wants to use. I truly believe thats...
Love the article but technically it did't help me at all. I completely understand about the vlans and making sure everything is labeled correctly. My issue I'm running into is the unmanaged switch that the customer wants to use. I truly believe thats...
Plug into another port and it comes up. Tried this as well before asking this question. So sense I have explained to you that I've tested the port every way possible, and plugged the cable into another port and it works. What would officailly make po...
Well for some of you that think I'm an idiot and don't know why I've posted this. I have rebooted the system, changed ethernet cables, and tested the port again. Port didn't come up. So to eliminate the end user I plugged directly into that same port...
