Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
receive this alarm from Monitor Platform for ISE Interface:As part of the analysis, I compared the behavior with the second Cisco ISE node, atollon (172.16.20.130). This node also has a cni-podman4 interface; however, it is in an UP/RUNNING state an...
I have a Global VPC in GCP in two regions, unfortunately the Cisco Multicloud Defense gateways are regional so I cannot connect two gateways in different regions to the same VPC.
Any ideas??I need traffic automatic switch between región if something ...
Hi all,
I have 6807 that not support bfd interval menor to 750 in interface.
someone can say me if next configuration with bfd template will work:
( I can't test in production 6807)
Device> enableDevice# configuration terminalDevice(config)# bfd-temp...
Hi,I have on-premise sdwan solution version 20.3.3.I'm trying upload un new wEdge from viptela.file, then when I sync the controller with new file the vbond send me this message:"Unable to get netconf client using connectionIP ...."the vManage show m...
I forget post the message:The virtual network interface cni-podman4 on host msa-cda-ise-02 (172.16.20.131) is persistently down — 19 out of 20 historical readings show value=2 (down), with only a brief recovery at 02:06:45Z before going down again. T...
Hi,
You can connect the MPLS link to one sdwan router and the Internet to the other sdwan router. implement tloc extension and you will get 4 links.
In relation to OSPF you can use any configuration depending on what you need.
Hi Flavio,
thank for you answer.
My example was wrong, in reality what I need is to apply the command in a vlan that is in a portchannel in a module that is not a supervisor. Even so, it does not accept lower values.¿ do you think the same ?
interfa...
