Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiAnyone have succes with creating a Webauth WLAN on a 9800 (17.3.1). Want to use 9800-cl internal webserver to do webauth but no success so far. Don't got login webpage and guides i have found are pretty bad. ThanksKasper
HiAnyone have luck with configuring 1540 AP in Bridge mode on 9800 Controller?Have tried with just MAC authorization but can't join 1540 AP's when putting them in Bridge mode.Running a eng. build a'la 16.12.4.ThanksKasper
Hi
Have a scenario with 8500-HA, 8.2.100, 3702/WSM.
Testing a specific WLAN and the following are observed... only on older Apple devices (ipad 2, ipad air 1, iphone4 running lates iOS). Wireshark shows the following:
EAPOL-key Timeout which add 1 ex...
HiIn a deployment with QoS configured on switches, we are going to do QoS on wireless as well (for LYNC optimization)Right now we use flexConnect on ver. 7.4.. Looking on the new AVC feature, it already have a profile for LYNC (when doing central swi...
From 17.15. Guide: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/17-15/config-guide/b_wl_17_15_cg/m_rrm_c9800.htmlCheck the Avoid Foreign AP Interference check box to cause the device’s RRM algorithms to consider 802.11 traffic from ...
Well, i must admit that i read this, as having site-tags sharing same Flex-Profile will give you key-distribution within site-tag
For FlexConnect deployments, site tag identifies the fast-roaming domain as client key caching and key distribution only...
Hmmm, Rich. Your post scare me a little bit as i was convinced that you don't need Flex Profile for every Site Tag to use efficient upgrade (This is just what i thought and not from any documentation). I ask our local Cisco dude and he find these TAC...
In 17.9.4 CSCwf09259 is not resolved in this setup "9800-80 (HA) /9120 + 2802 running 17.9.4.27"
When reset AP switchport with LED state: disabled it comes up with LED state: enabled
