Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day, I am trying to setup Aero Scout Exciters (Chokepoints) to map RFID tags (AeroScount Tag T2) to a specified map when passing the chokepoint. I was told by AreoScout that we could use the Exciters to map tags to a specific floor to help corr...
After reviewing some of the Cisco documentation on integrating WLC with NAC, requiring the WLC to be L2 adjacent to the CAS, I am assuming that the WLC can not be configured to use LAG on the 4400 seies WLC, a specific port on the WLC must be assigne...
We have a L3 OOB, workstations are using the CA Agent, both XP and Vista machines. After login the CA Agent keeps looping, refreshing ip successful, the switchport never changes from the untrusted Authentication VLAN to the Access VLAN, the workstati...
Good Day, I have a site that has reduntant 6513's at the core showing high cpu usage on bpdu Tx Rx, I checked all access layer switched for port flapping, did not see any interface resets higher than a count of one. They are using PVST+ with 96 vlan...
We have a stack of 4 3750s 2 of the switches are running EMI code two are running SMI code, looking for a way to upgrade the IOS with these two different version. Thanks Rich
No other error messages, just looping throught refreshing IP, I did get a call back from TAC, the issues was that after working with a number of TAC Eng during the installation, one TAC eng had me remove the managed subnets and create static routes. ...
We have been fighting this issue for a few weeks. This site has about 200 users, one site-to-site vpn, dynamic client vpn, CBAC, NAT, 3 interface route setup with DMZ, and of course Websense intergration. It appears to much better with the websense i...
Did you ever get a resolution to this issue? I am having the same issue with the websense url filtering on a 2811, but with far less users and tunnels.Thanks Rich
That is my concern, we only want the master and one other switch to run EMI code, the other two run SMI code, which poses an issue with this configuration if the stack doesn't get powered up in order one of the switchs that is running SMI will become...
