Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've looked through the Cisco config guides for setting up Config sync and have successfully used it to configure dual-homed FEX's ports.Is there anything I should be aware of that can cause issues?I enabled config sync on an existing pair of 5Ks. I...
I'm running an ASR1001 with IOS-XE version 15.1(3)S6.I don't seem to be able to apply a policy-map to a tunnel interface that running in "tunnel mode ipsec ipv4". The router gives me the error: Error: NBAR is not supported on Tunnel227. When I try...
I have configured the G0 interface with an ip address and placed it in the Mgmt-intf VRF. I can ping the management ip address accross my WAN but I cannot SSH to it. I can, however, SSH into any of the transit interfaces.Thank you in advance for an...
On working on a FWSM using ASDM 5.0F.I was trying to add another host to one of my object groups but was getting the error "this operation will result in some security rules getting nullified. Please review your translation/security rules before retr...
I'm having a strange issue. I'm running a 3560 8 port switch with c3560-ipbasek9-mz.122-58.SE2.bin.Here is the relevant config:interface Vlan140 ip address 172.20.40.18 255.255.255.0ip route 0.0.0.0 0.0.0.0 172.20.40.1aaa new-modelaaa group server r...
Okay thank you Amit. That's what I thought. I couldn't find that information in the Cisco docs so I just wanted to see what was everyone else's experience. In the past I configured config-sync on brand new pairs of nexus 5Ks but never really on an...
Thank you Reza,To confirm what you just said.I am no longer allowed to make individual changes to individual ports?I want to use config-sync to make changes to my FEX ports since the FEX are dual homed. But, there are instances where we might one to...
Hi Richard. Thank you for your response. Are you saying that once config sync is enabled, I should no longer make changes on the individual switch in conf terminal mode? What if I was just connecting a server to one 5K and do not need to configure a...
I did some searching and it looks like some "match protocol" statements may be using nbar. How do I distinguish which "match protocol" statement is using nbar and which one is not?Vince
Hi, yes, I have that line in there as well. I'm trying to ssh into the switch and authenticate using radius. I am able to SSH in, but when I attempt to authenticate, it doesn't look like the switch is communicating with the radius server at all. A...
