Hello, I've developed an architecture based on the Phone CSS in order to route the calls to the PSTN with the root number assigned (from the provider) to a certain site. The customer has two routers that handles all the PSTN number that he bought form the Service Provier (Refer to this infrstructure as a Centralized CUBE PSTN Access) and the Service Provider has disposed (for legal reasons) that every call must have the CLI set to the number of the site where the call originates. For instance: Call placed from Site A ----> PSTN 061234 Call placed from Site B ----> PSTN 021234 Anyway, the customer has also configured the Extension Mobility service and the wants to keep this behavior also when a user roams to another site. The current architecture is developed this way: -     The phone has CSS that allows any calls 0.! -     The Line CSS associated to the device profile blocks, with some Translation Pattern, the calls that the user should not place to the PSTN -     The correct root number is re-writed on the Route Pattern Calling Party Tansform Mask (that is contained inside a partition matched by the Phone CSS) This configuration allows me to match always a Route Pattern for a certain Site and assign the correct Calling ID without the need to be aware of which gateway I've used, that's why I need to have redundant path to PSTN. Everything is working fine except when I need to forward to the PSTN the Direct Inward Dial information into the CLI. E.G.: A user has a 5678 Extension on his device profile, he is a user @ site A: 1st CASE: When he is in his home location he matchs the CSS of the site A that use the Route Pattern 0.! that re-writes the CLI this way 061234XXX the three X will be replaced with (678) and the call will be placed to the PSTN this way 061234678. 2nd CASE: When he roams to the site B he matchs the CSS of the site B(because he use the PHONE CSS) that use the Route Pattern 0.! (for the site B) that re-writes the CLI this way 021234XXX the three X will be replaced with (678) and the call will be placed to the PSTN this way 021234678. I don't want to allow the user to forward to the PSTN the number "021234678" in the 2nd Case because the internal Dial Plan is overlapping for the last three digits so, I have to inhibit this behaviour. The best solution would be to forward to the pstn just the root PSTN number in this case. I'm looking for some mechanism that allows me to realize this architecture, I would be grateful if you might want to share your ideas. I tryed to be syntetic and provide all the informations, but if you might want to help and you need some more details please don't hesitate to ask me. Thanks in advance Andrea ... View more

Hello, This is my topology:              SITE A                                              SITE B MD110 ----qsig---- VG2951 -----mpls----- VG2851 ----qsig---- MD110 (Third party VoiceMail) I'm experiencing a strange beahvior when a digital Phones forwards the call in to the Voicemail and when I enable the "qsig decode" command under voice service voip global config. Without the command issued: When I place a call from Site A to Site B all the IE facilities are passed correctly between the call parties, everything works fine, unless the phone in the site B forwards the call to the voicemail, in this case the call is not forwarded and the phone B continues ring. With the command issued: (Same call parties) The call is forwared correctly to the voicemail but the IE Facilities are not displayed on the phones both before and after the call is answered. Does anyone have any ideas about this issue ? Any help is appreciated. The configurations are attached Thanks Andrea ... View more