Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
I want to monitor my network devices (switches and routers). For example on switches, I want to get information only on some uplink interfaces status(up, down, bandwidth utilization) and CPU. I don't want to get information on all other...
Hi everyone, I have a problem with site to site vpn between two cisco routers. Here are the configurations:Site Acrypto isakmp policy 10 encr 3des authentication pre-share group 2 lifetime 86000crypto isakmp key secrettestkey address x.x.x.x!!crypto ...
Hi everyone, We have Cisco VSM 7.5.1 version installed. We want configure first stream only for live view, and secondary stream for recording.On template we turned off recording on first stream, and turned on recording on second strean and applied it...
hi everyone. we have sever with cpam 1.5.1 installed.we need to configure authentication with two badges. for example to open a door two persons have to swap their badges.or to enter a restricted area badge of person and badge installed on car should...
Hi,We have upgraded our VSM servers from 7.2.0 to 7.5.1.After upgrade we faced some problems.First, can you please describe what does this warning means? Pending software Upload - MS-s/Vsom do not have these software uploaded Second,When viewing from...
Hi Mattjones03,
Thank you for your reply. I will try that software. But I was wondering, are there any command line configuration on switches or router, which can limit sending snmp information like I asked before, or it should be done through softw...
Hi Poonam,I tried that, but doesn't help. here is the some debug output: Jan 26 04:35:34.679: ISAKMP:(2081):purging node 613514273Jan 26 04:35:34.679: ISAKMP:(2081):purging node -156888705Jan 26 04:35:39.707: ISAKMP:(2083): retransmitting phase 2 QM_...
