Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I*. using PCP 11.6 on CUCM 11.5 cluster. When I manually provision extension mobility access and line for 7962 phones on a user I notice following issues:
- the provisioned user device profile in CUCM does not have the SoftKey template that is...
Hello,
I'm trying to migrate a cluster with two CUCM 9.1.2.13900 and two IM&P 9.1.1.31900 server both to 11.5.1.11900.
PCD version is 11.5.3.10000 running on ESXi 5.5.
the UC cluster is discovered successfully and I have started a migration task to...
Hello,
version 11.2 of PCP supports writing back assigned directory number, when a user is auto-provisioned and a directory number is automatically taken from the service location number block. that is working fine so far.
Let's assume the user was p...
Hello,
when I do provisioning of a Extension Mobility access device that has the Exntension Mobility service subscription assigned to it the probisioning job ends in hold state with error message:
"Error adding User Device Profile. IPT-0500: Object N...
Hello,
I'm using PCP 11.1.0 and have setup service templates for extension mobility access and extension mobility line. When I try to provision extension mobility and lie for a user, the celection of extension mobility type is required but the corre...
Hello Chris,
root cuse in my case was wron ISO image. it was made bootable from an CCO downloaded upgrade image. PCD 11.5 for mistake detected this as an UNRESTRICTED image.Here are the relevant lines from the ucmap log file.
You have to use origina...
Hello,
some further inverstigations showed that there is a relation to the ISO image you are using to install CallManager:
- upgrade only ISO images, that were made bootable i.e. with MagicISO are causing the error
- original bootable ISO image from ...
Hello Manish,
you are right. after infrastructure sync the drop-down menu in extension mobility acces device's service URL contains '&EMCC=#EMCC#', that was missing before.
Thanks
Juergen
Hello Steffen,
I've got the same issue with 11.2, but did some more testing and was able to fix it. I found out, that the user role must have at least one endpoint service assigned. It is not necessary that the user has an endpoint of that type provi...
