Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Meraki fans I have a problem with connectivity status of my switches and APs. After some test I'm sure that this is related with the firewall policy I setup. At the end of my firewall policy I added "Explicit rule"I added also rules which allo...
Hello Everyone
I have a problem with upload new SSL certificate to my anchor WLC. Controller is old - 4402 with the newest available software. During the download certificate I get en error - from the GUI I get information "File transfer failed!" bu...
Hi,
I'm trying to configure SSO between two 5508. Everything is working almost excellent but when I'm trying change Mobility MAC to different one, I cannot do this :(.
After I configure mobility mac on both WLCs it's look like my new settings has b...
Hi
I have 2x5508 working on the code version 8.0.133. Both controllers are in the same subnet and they are in one mobility group. After the upgrade to the code 8.0.133 (maybe this is only coincident) APs can not create DTLS tunnel and join WLCs. Thi...
Hi,
I have Cisco Prime 3.1 installed on the appliance Gen2. This server has 2 Gigabit links, I can see them form the CLI.
Can I configure HA - Active - standby of the physical link? - I mean interface Gigiabit 0 connected to "switch 1" and gigabit 1...
Version of the OpenSSL:
OpenSSL 1.0.1l-fips 15 Jan 2015
What do you think about this? Is this is the root cause of my problem? If yes then please tell me why?
WLC code is 7.0.252 (the newest available for 4400), I'm not sure what openSSL was used to create certificate because I did do this - I had a problem with my OpenSSL so I asked my collage to do this. He used OpenSSL from his LAB load balancer F5 :).
