Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Could some one confirm if the TCAM space utilization remains same if the same ACL is used across many ports on sup32-3B/6500 as this behavior is purely dependent on hardware. From my initial testing (tried on two ports) it appeared so, but would l...
We are planning to use Cisco AnyConnect Network Access Manager as a 802.1x supplicant for our wired network as we ran into issues with Microsoft native supplicant. There are certain advantages in using inbuilt supplicant on Windows as one can get de...
I have a scenario where there are 3 WAE devices used in a site. We are using MASK of 0x3F (6 bits) on source IP address for distribution to achieve as fair a bucket distribution to the devices as possible - 21 buckets, 21 buckets and 22 buckets. I un...
Cat 3850s provide unified access and WLC functionality. However, I would like to know if they can act as foreign controllers. In other words, can we host a wired guest VLAN on 3850 and tunnel its traffic over EoIP tunnels to a guest anchor WLC (5500/...
On googling I came across documents that say OTV (Overlay Transport Virtualization) is supported on Cat 6500. Does anyone have authentic information whether OTV is supported on Cat 6500, especially with Sup-720B? FYI, Cisco Feature Navigator does not...
I haven't found any knob to create a deterministic assignment of buckets to WAE devices in the cluster. However, after toggling WCCP on my router it restored the assigment to original one. 0 to 20 buckets - wae121 to 41 buckets - wae242 to 63 buckets...
Thanks Gaurav. I was suspecting that. However, that does not seem quite right to me. This makes the assignment non-deterministic and has unwanted effects as we are facing now. Though not frequent, a WAE in the cluster going down/coming up is not a to...
