Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, teamI have got LMS 4.2 and frame-relay network with old cisco equipment. In topology view some serial bus on link appear, but on other links serial bus not appear. I compaired configuration, IOS version, HW releases and all the same. CDP enabled ...
To investigate issue need to perform some tests:
1. Check mem-low alarm in CTC2. Reset control cards on any node and check snmp again3. Check firewall between nodes and NMS system4. Check GNE mode on nodes connected to LAN and ENE mode on nodes not c...
Hi,
CPU utilization. For a long time there were no cases of a high load of the system. If there are hight CPU it mean that system making DB backups or clearing memory. You can manually perform pulling through telnet CPU or memory performance by comma...
Each ONS\NCS system\node can store optical performance for 32 number of intervals divided by 15 minutes. For long-term storage of statistics need to use Cisco Prime Optical server, witch could store optical performance statistics as long as you want....
Hi,
Try next steps:
- check FEC mode on both side
- check service type on client ports (Eth\SDH\VDI\other)
- check\change pacthcords on both sites
- reboot cards
