Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 sites on Metro Ethernet connected the 4th site is using a VPN to Head site. Metro E sites are all connected via eigrp to route traffic. What do you suggest how to route traffic from the vpn site to all 3 sites. I am having issues setting up ...
I have a router 3925 that has a public ip address on g0/1 and I am need to connect a device on G0/0 that receives and DHCP public ip address so a Vendor can vpn into with.
I tried settng up DHCP but it doesn't hand out an ip address on G0/0. Any su...
I am replacing a pair of Nexus 5K using HSRP with VSS 9500x40. The SVI have dhcp relay on all the interface the same commands doesn't work on the 9500. What would be the commands to replace this. I am not sure if relay is even needed since dhcp serve...
I been using static nat and has been cumbersome to manage. For example I will do a /24 static nat to make all the NATs are known for monitoring. Question came up that can we NAT a subnet and they will always line up with last octet the sameexampleip ...
So I have a switch in between Router and ISP. G0/0 has a static ip for site to site vpn. I have this aruba device that needs to be connected via outside public ip address. I can setup the switch as a DHCP server however I will use 2 public ip address
Great thank you I see 1gig GLC-TE will work. I assumed 10G RJ45 was supported however in that chart there isn't one listed. Do you know what model for 10G?
