cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1040
Views
40
Helpful
10
Replies

C9500 and SFPs

jfeo
Beginner
Beginner

Does anybody know if Cisco Catalyst C9500-40X-A ?switch can support 1Gig Rj45 sfp 

10 Replies 10

Seb Rupik
VIP Advisor VIP Advisor
VIP Advisor

Hi there,

yes, confirmed here:

https://tmgmatrix.cisco.com/?npid=190

 

The SFP-GE-T is listed.

 

cheers,

Seb.

jfeo
Beginner
Beginner

Great thank you I see 1gig GLC-TE will work. I assumed 10G RJ45 was supported however in that chart there isn't one listed. Do you know what model for 10G?

You are thinking of the SPF-10G-T-X:

https://www.cisco.com/c/en/us/products/collateral/interfaces-modules/transceiver-modules/data_sheet_c78-455693.html#CiscoSFP10GTXmodule

 

...according to the tool, that is only supported on the C9500-24Y4C and C9500-48Y4C:

 

https://tmgmatrix.cisco.com/?tpid=961

 

cheers,

Seb.

Seb Rupik,

   How come a Cisco GLC-10GBase-T SFP+ will not work with the Cisco c9500-48y4c if it has 48x 10G capable interfaces? Are those interface designed only for optical sfp's? I hit a massive issue where I thought this switch was able to use 10G copper sfp's but none of them will work and they are getting errdisabled for not being supported.

To clarify, I have Cisco GLC-10G-T-X SFP+ but none of them will work and they are getting errdisabled for not being supported on all 48 interfaces

Hi there,

What software version are you running on the c9500-48y4c? Those SFPs have a required minimum version of 17.4.1 .

cheers,

Seb.

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

you mean GLC-T yes it does support, there are some version has some bug (i dont remember) the port show always up even you remove the cable, so make sure you have right version of code like 17.3.3 or above.

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

I can't find any document that says the Cisco Catalyst C9500-40X-A supports both 1&10 GIG RJ45 SFP. Can someone please confirm

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

1 and 10G support, I have tested 1GB GLCT - community many people used 10G Copper SFP and confirmed it works.

 

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Leo Laohoo
VIP Community Legend VIP Community Legend
VIP Community Legend

@jfeo wrote:

Great thank you I see 1gig GLC-TE will work. I assumed 10G RJ45 was supported


Not all firmware can support SFP-10G-T-X.  

You are better off raising a TAC Case because the TMG page rarely gets updated correctly.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers