Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to use C1111-4P as terminal server for other router's console port.
I found past discussion in below, and I tried to make it, but not successful. (attached is current config)
https://community.cisco.com/t5/other-network-architecture-subjects/i...
C1111-4P has only one serial port (con 0)
I tried to use the port for accessing console of another router, but telnet is rejected.
#telnet 10.10.10.10 2000Trying 10.10.10.10, 2000 ...% Connection refused by remote host
10.10.10.10 is loopback of C111...
I am firstly setting up C9800 , but AP join is not working and stays in "ap auth pending".DTLS session is established by checking "Monitoring -> Wireless AP statistics -> Join statistics".I tried adding AP mac address in "Tags-> AP -> Static" , but i...
I configured ISATAP between two routers.[Server cisco3845 ver 15.1(4)M12a]interface Tunnel4 no ip address no ip redirects ipv6 address 2001:22:33::/64 eui-64 ipv6 enable ipv6 nd cache expire 10 no ipv6 nd ra suppress tunnel source Loopback0 tunnel mo...
It seems to be very strange because the initial post of this thread has following
router#sh spanning-tree sumSwitch is in rapid-pvst mode
If you have output of "show spanning-tree summary" before entering command for rapid-pvst mode, it may help to ...
After enabling "debug telnet", I can see debug log when I make normal telnet (port 23), but cannot see any log by telnet with port 2000 or 2001.
I guess telnet process on router is not listening incoming connection with port other than 23
