Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day.
Please review topology used:
R1 and R3 - both ASBRs and redistributes information about connected networks 11.11.11.0/24 and 33.33.33.0/24. AREA1 is NSSA Area.
Both interfaces on R2 in directions to R1 and R3 have cost of 10. But take a ...
Good day.I am curently trying to familiarize myself with catalyst QoS, and need explanation about some comands generated after applying auto qos voip cisco-phone to switchport.As i noticed with this comand "service pollicy" is generated and applied ...
Good morning, everyone! I need some clarifications regarding ouput of show ip cef switching statistic on Catalyst 6k and some entries apply to other platforms as well. Consider output:#show ip cef switching statistics Reason ...
Good day, everyone! )I heard at Cisco Live and lately red in CCDP Cert guide thatA major benefit associated with IPSec VTIs is that the configuration does not require a static mapping of IPSec sessions to a physical interface Hm, but from my point if...
Good day!I am a bit confusing with real DRAM size on my RSP720-3C-GE, as it stays in cisco documents it is 1G DRAM minimum:•PFC3C and MSFC4 with 512-MB bootflash, 4-MB NVRAM, 4-MB ROMMON, and several DRAM options:–Route processor (RP): 1- to 4-GB DRA...
Hi Aleksandar,
Thanks for answer! No, there are no ARP punt counters and DROP counters on NP3, I mean they are zero. And code, unfortunately, is 5.3.1.
Yes, SR opened.
Hi Aleksandar,
All ports belonging to np3 of A9K-8X100GE-L-SE have same issue with ARP (and all other packets also but lets consider ARP). I see on the port (TenGigE0/1/0/6/0) ARP requests from connected device to ip address assigned to this port it...
With Type5 it seems obvious, but with redistributed loopback as to me there are a couple of differencies. Nevertheless it seems that behaviour is the same
You didnt get my point - i mean cos i redistributed connected loopback interface, therefore its own cost cant affect forward metric calcultions (ospf even not enabled on it).
BTW i checked changing cost on Lo0 (3.3.3.3) and it seems that its cost ...
