Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears, I would like to implement the below design , and im wondering if its going to be valid. PC(Access vlan 10)-----------SWITCH(SVI Vlan 10 , Vlan 20)------Trunk-------Bridge group 1-----ASA(Transparent)--Bridge group 1-------Trunk----Switch(SVI v...
Dears, If i have 2 Nexus7k with 2 vDCs created , one for campus and the other for DC as show below :-can i have this setup(VDC Campus)N7kA----Trunk-----Bridge 1 interface---ASA1------Bridge1 interface-----IPS----Trunk--N7kA (VDC Datacenter) So basica...
Hello im having a very basic topolgy where 2 routers directly connected and running RIP V1Lo1----R1-155.10.2.1/24--------------155.10.2.2/24--R2Lo1 is 155.10.3.1/32Now what i know about RIP V1 is that it's Classful routing protocol so in this case R1...
Guyz i was wondering if i can have end to end vPC feature enabled between 3850 connected to 2 x 4500 and each 4500 has 2 uplinks to 2 Nexus7k , how can i have all the links to be fowarding in that case
Actually i just checked and yes all the SVI's created on core switch does have Proxy-ARP enabled by default , so L2switch broadcast ARP request , Core switch recieve it and then reply with VLAN 2 SVI mac address to L2switch.Please correct me if im wr...
Actually im not sure tomorrow ill check this out when im at the customer site , but if proxy configured on the core then in this case how the L2 switch will be able to reply to the ping requests
