Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About steve.blunt
Stats
Member since
05-22-2009
36
Posts
0
Helpful
1
Solution
Certifications
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-03-2019
07:55 AM
12-03-2019
07:55 AM
The reason for wanting the MX to provide DHCP is simply this is the case for the clients legacy on-prem wireless LAN controller. Effectively the client will need to provision a DHCP server for the Meraki solution as this functionality is not supported...shame really
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-03-2019
07:15 AM
12-03-2019
07:15 AM
Hi thanks for coming back, all I'm looking for is for the MX to be a DHCP server when used to terminate SSID tunnels, Meraki's validated design says use one-arm pass through mode but does not mention DHCP capabilities
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-03-2019
06:08 AM
12-03-2019
06:08 AM
Hi thanks for the reply. I was lead to believe the MX in VPN concentrator mode (one arm) was not capable of running client DHCP services. I'm struggling to find anything official in writing
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-03-2019
05:43 AM
12-03-2019
05:43 AM
I think this is saying that the MX receives its IP address via DHCP, the documentation does not refer to the MX been able to run DHCP services to facilitate client addressing
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-03-2019
01:42 AM
12-03-2019
01:42 AM
Hi, yes I have seen this guide thanks, but there is no reference to DHCP capabilities. All that is required is for the MX to support DHCP for clients connecting to an SSID which terminates its tunnel on the MX
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
12-02-2019
07:04 AM
12-02-2019
07:04 AM
Hi is it now possible to configure MX appliances in SSID VPN termination mode to act as a client DHCP server, this was not supported last time I looked. Thanks
... View more
- Tags:
- meraki
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
11-26-2019
08:35 AM
11-26-2019
08:35 AM
Many thanks
... View more
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
11-26-2019
08:25 AM
11-26-2019
08:25 AM
Hi can anyone confirm or provide any tips in relation to if the Wireless Controller (Field Upgrade Software ) update is required when upgrading from 8.2.151.0 to 8.5.151.0 on an older 5508?. It doesn’t appear a requirement within the release notes. However I just wanted to double check before moving forward. 8.5.151.0 release notes https://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn85mr5.html#software-rel-types-and-recommendations_85_mr5 Thanks
... View more
- Tags:
- wlc 5508
Labels:
11-21-2019
12:59 AM
Hi, I now understand from a technical perspective, shame clients end up having to purchase a license that may never be used though
... View more
11-20-2019
07:41 AM
Hi, I don't normally specify security products and would welcome clarification re the below in reference to the ASA5516-X with Firepower ( ASA5516-FPWR-K9) 1. In a HA (active/standby) deployment is it mandatory that I need to purchase a L-ASA5516-TAMC URL, AMP and IPS license for each appliance.? I would have thought not as these are subscription based and the secondary firewall should hopefully never activate or only be active for a short period. 2. Table 3 in the datasheet below says that the Security Plus license is not required for the ASA5516-X in any HA mode. Is this still correct based upon I want to license the deployment with the L-ASA5516-TAMC? Thanks https://www.cisco.com/c/en/us/products/collateral/security/asa-5500-series-next-generation-firewalls/datasheet-c78-733916.html
... View more
Labels:
09-27-2018
08:13 AM
Can I confirm that the SG110:
Does not support 802.1x
VLANs i.e. 802.1pq
Is not software upgradeable
Thanks
... View more
Labels:
Created by
steve.blunt
in Other Wireless - Mobility Subjects
in Other Wireless - Mobility Subjects
11-15-2017
12:34 AM
11-15-2017
12:34 AM
Thanks, it seems that only the UX APs still manufactured are the 37/2700 series.
... View more
Created by
steve.blunt
in Other Wireless - Mobility Subjects
in Other Wireless - Mobility Subjects
11-07-2017
09:27 AM
11-07-2017
09:27 AM
Thanks, will do!
... View more
Created by
steve.blunt
in Other Wireless - Mobility Subjects
in Other Wireless - Mobility Subjects
11-07-2017
08:38 AM
11-07-2017
08:38 AM
I have a client who wishes to utilise a "mobile" WiFi platform to provide temporary coverage within differing WiFi RF regulatory regions i.e. Europe, Japan, North and South America, Australia/Asia PAC. The solution would be purchased in Europe but would be transported globally as needed. The solution would be controller based (5520) and ideally use outdoor rated APs ( AIR-AP1562D-E-K9). I'm concerned that the AP's may have their regulatory domain "burnt" in, so will not support the necessity to be reprogrammed dependant upon where they are physically in use. Can any one qualify please? If there is an issue with the AIR-AP1562D-E-K9, is there another viable option using cost effective outdoor rated APs or even say 2802E deployed in IP56 rated containment
Thanks
... View more
Labels:
Created by
steve.blunt
in Wireless and Mobility
in Wireless and Mobility
05-30-2017
08:55 AM
05-30-2017
08:55 AM
Hi all, does anyone know if there are there any functional limitations when implementing Flexconnect using a centralised Mobility Express AP based controller? I have a client that is looking to migrate from 2504 based systems with APs deployed in Flexconnect mode, the WLC supports a small number of APs deployed in different WiFi regulatory domains. Also are there any issues / capabilities in respect to a central controller to implement WiFi regulations on a per region basis e.g. a Mobility Express controller deployed in ETSI with a few APs in FCC, South Africa etc?
... View more
Labels:
Created by
steve.blunt
in Wireless and Mobility
12-03-2019
12-03-2019
The reason for wanting the MX to provide DHCP is simply this is the case
for the clients legacy on-p...
Created by
steve.blunt
in Wireless and Mobility
12-03-2019
12-03-2019
Hi thanks for coming back, all I'm looking for is for the MX to be a
DHCP server when used to termin...
Created by
steve.blunt
in Wireless and Mobility
12-03-2019
12-03-2019
Hi thanks for the reply. I was lead to believe the MX in VPN
concentrator mode (one arm) was not cap...
Created by
steve.blunt
in Wireless and Mobility
12-03-2019
12-03-2019
I think this is saying that the MX receives its IP address via DHCP, the
documentation does not refe...
Created by
steve.blunt
in Wireless and Mobility
12-03-2019
12-03-2019
Hi, yes I have seen this guide thanks, but there is no reference to DHCP
capabilities. All that is r...
Created by
steve.blunt
in Wireless and Mobility
12-02-2019
12-02-2019
Hi is it now possible to configure MX appliances in SSID VPN termination
mode to act as a client DHC...
Created by
steve.blunt
in Wireless and Mobility
11-26-2019
11-26-2019
Hi can anyone confirm or provide any tips in relation to if the Wireless
Controller (Field Upgrade S...
11-21-2019
Hi, I now understand from a technical perspective, shame clients end up
having to purchase a license...
11-20-2019
Hi, I don't normally specify security products and would welcome
clarification re the below in refer...
09-27-2018
Can I confirm that the SG110: Does not support 802.1x VLANs i.e. 802.1pq
Is not software upgradeable...
Created by
steve.blunt
in Other Wireless - Mobility Subjects
11-15-2017
11-15-2017
Thanks, it seems that only the UX APs still manufactured are the 37/2700
series.
Created by
steve.blunt
in Other Wireless - Mobility Subjects
11-07-2017
11-07-2017
I have a client who wishes to utilise a "mobile" WiFi platform to
provide temporary coverage within ...
Public Statistics
| Date Registered | 05-22-2009 12:44 AM |
| Date Last Visited | 03-27-2020 03:00 AM |
| Total Messages Posted | 36 |
