Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am following TAC Document 116358 " NCS Integration with ACS 5.4 Configuration Example" and on task #9 where it states " 9. In the Conditions area, choose the appropriate conditions. In the Results area, choose NCS for the Shell Profile. In ACS 5.4...
I am running Prime 1.4 to manage two 8510 WLC's both running 7.4.110.0 but there is a mismatch on the audit status between what Primes says the WLANS that an AP has vs what the controllers has. I know that the controller takes precedence but I can ...
I have numerous access points, both 3502 and 3602's that are connected to Cisco 2960s POE switches that will disassociate and then reassociate themselves with the WLC. The WLC and access points are running 7.4.110.0. The particaular Cisco 2960s POE...
Is it possible to configure a Cisco device(aka, switch) to use a tacacs server that has both a local db and an external db? I currently have a test switch that is configured to use TACACS authentication where that authentication is an active direct...
Because of a bug in the 7.4.100 code running on the pair of 8500 WLAN controllers in SSO mode, I need to upgrade to 7.4.110. What is the best method of updating these controllers to that latest stable code? I am running Prime NCS 1.4.
So is option 43 and option 60 even necessary? I will be running both Cisco 3500 and 3600 series accces points. We want to avoid having to create separate dhcp scopes for each model of AP. We are going to be migrating 800+ access points from WCS 7.2...
I did find out that I can create a dhcp scope (option 43) for each specific access point that I have that will tell the AP which controller to connect to. Since I will have both 3500 and 3600 series accces points I will have to have two separate dhc...
