Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,the Switching Capacity of the Catalyst 9600 (using SUP1) is up to 9.6 Tbps, but the datasheet highlights that the Switch is ready to support up to 25.6 Tbps ! is there any new supervisor in the roadmap to be able to reach that Switching capacit...
Hello all,I have deployed the following configuration for Exchange 2010, if all services are up on the two servers it functions good but if a service goes down on one server (especially outlook) some clients are disconnected (stickiness) ...Stickines...
Hi all,i need help in configuring ACE 4710 to hide Oracle application server port (tcp 7777) from the URL.the load balancing betwwen the two servers is functioning but i need to eleminate the port from urlthe clients access to http://www.example.com ...
Thank you for your email. I am out of the office until March 25th, I will have limited access to my e-mail during this period. In my absence, please feel free to contact Mr Akram Allani : aallani@3s.com.tn Thank you for your understanding.Best regard...
Hi Surya, When we shutdown a service on one node, the probe comes down (working fine) but in the sticky database it's still there !!!!that's why Clients have problems (especially Outlook which has three services) !!!A case is openend with the TAC .R...
Hi All,Any help about the configuration provided !!The problem that Outlook especially desn't work because of stikiness .has anyone tested this solution "ACE Module for Loadbalancing Microsoft 2010 and LYNC or OCS" !!!Best Regards
Hi all,i have done the same configuration but it still not functioning, this is the configuration:config:access-list BPDU-Allow ethertype permit bpduaccess-list portal-acl line 1 extended permit ip any anyprobe tcp HTTP7777 port 7777 interval 30 p...
