Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have a uc540w which has a number of extensions configured and a multisite configuration as well. All works well, however it will not save any changes or allow adding new extensions and phones. All goes well when configuring in CCA 3.2.3 but the...
I have 6 spa509g phones attached to a uc540. Until recently everything has been fine, lately I have one phone that randomly goes into initializing network and then downloading. Eventually it comes back up. It does this a few times per day. any ideas ...
I have 6 spa509g phones attached to a uc540. Until recently everything has been fine, lately I have one phone that randomly goes into initializing network and then downloading. Eventually it comes back up. It does this a few times per day. any ideas ...
I am re-wording this question. I have a cyberdata sip endpoint amp. It is registered, connected, has an extension. when i dial the extension it gives a fast busy. When i check the logs it shows that the call is going out through the sip trunk to our ...
I am setting up a Cyberdata sip endpoint for paging. I have successfully installed the cyberdata sip intercom on other systems (uc540) and they work well. I am not having much success with the amp. I have tried many configurations in both the uc540 c...
I had a similar problem with the uc520. After several tries I set the install to factory reset the uc520 and it worked. I had extensive customization on the box that I had to redo.
Thanks David. I will try to sbcs to cooperate. They don't like to help support 3rd party products. They may be willing to help create a sip-dn, and then I can take it from there.
this is a paging gateway for loudspeakers. The intercoms that I have configured are working fine. if you like to see the settings I used let me know. When someone presses the call button I have it ringing to a call blast group, when they answer they ...
I tried that already, In fact I had the settings at "sip only" since I got rid of the pstn lines, a year ago. I am trying to add a fax line as incoming only, to use it as a failover for sip, since the fax does not accept inbound calls anyway. The pro...
