Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, Do you know how to obtain information about PPPoE Subscribers via YDK-PY on an ASR9k? I found some ppp information in the YDK model Cisco_IOS_XR_ppp_ma_oper, but I can't filter based on username.The idea is to get statistics from subscribe...
Hi all,I'm using Cisco Linksys RV-042 with the V2 hardware to configure a VPN tunnel that route all traffic to remote gateway (a Cisco ASA 5510). This setup works fine, and I can access the local router and all other resources at central site.But I'm...
Hi all,In the WRP400's datasheet specifications:"Data networking - IPv4 (RFC 791) upgradable to v6 (RFC 1883)"But I can't find anything (and anybody) about using IPv6 in this router.Are anybody using it? What v6 features are supported?Thanks,Rafael
Hi All,Is it possible using ASA without GRE tunnels to pass OSPF traffic and set an OSPF area ID for each VPN peer/neighbor?I'm testing with an internal lab and worked only with one OSPF area for all VPN peers. Just as the Cisco site example [1]. If ...
Hello @saalvare , thanks for the help. I think the node Interfaces is just what I'm looking for. Do you know how can I obtain just the Interfaces class from the Node? I've setup a lot of filters, without success: pppoes = pppoe_ma_oper.Pppoe()
...
I'm not using overlapping networks...Local RV network: 10.0.30.0/24Remote network: 10.0.1.0/24But the VPN configuration is:Local RV network: 10.0.30.0/24Remote network: 0.0.0.0/0 (to route all data traffic to remote gateway)This setup works in V2 har...
Is it possible to route all traffic to a remote gateway using the RV-042 V3 hardware version? When I use the V2 hardware, I can access the rv-042 when the VPN is up, but if I use the V3 hw, I can't access the router until the vpn goes down....
Then for each remote site has it own area ID I must use GRE tunnel, between two routers (or another capable ospf/gre device) before the ASA Lan2Lan? Is It right?
Thanks Halijenn!But is it possible to set an different OSPF area ID for each 'neighbor' configured? Or just the same OSPF area of the interface?The idea is that each remote site has its own area id.Regards,Rafael
