After upgrading our RV220W router to 1.04.17 firmware I am getting the following error message consistently.PLATFORM [System] /pfrm2.0/bin/bwLimitConfig /tmp/system.db 18 dot11STA 10 failed. status=-1What does it mean? How do I get rid of it...
I updated the firmware on my rv220w router to the latest 1.04.17. I am now getting the following errer every 3 to 15 minutes. "PLATFORM [System] /pfrm2.0/bin/bwLimitConfig /tmp/system.db 18 dot11STA 8 failed. status=-1". what do...
I have two sites using a vpn tunnel on RV220W routers on each end. I have a SIP ATA switch for VOIP at each site. I also use SIP trunk to an external provider from each site. If I enable SIP ALG, SIP traffic through the VPN tunn...
I have the RV220W and we are mainly using PPTP for VPN access. I can not add more than 9 PPTP VPN user acounts. When I go to add a tenth account the interface just hangs and stops responding. I can delete a user and then add another user and...
I have two offices connected with an IPSEC VPN tunnel using RV220W routers. The Tunnel works fine for local users between the two sites(Site 1:10.0.0.x; site 2 is 10.0.2.x). I have also set up PPTP users for remote access. PPTP users that connect ...
I set up one to one nat on each system since I have multiple public addresses and I set the system up to use the public addresses.....this seemed to help, I can now call an extension at the other office. the phone call connects and everything seems ...
I changed that to 11 and it let me add a tenth user account. I guess I am surprised that the limit is on the number of user accounts that can be added and not on concurrent active sessions. I understand now...thanks for your assistance.
Yes(192.168.50.1 to 192.168.50.10). But I am not talking about concurrent usage. I am just trying to add PPTP user accounts. If I delete a PPTP user account it will let me add a PPTP user account. However, It will not let me add more than 9 PPTP...
Thanks for the insight.....Once I added the additional tunnels PPTP worked great(as well as SSLVPN - with the appropriate tunnel). QuickVPN did not work, but I suspect that this is because QuickVPN uses IPV6. Unfortunately I am not versed in IPV6 ...