Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I am trying to configure a simple applet on the ISRG2 routers after entering the action for email, the variables end up being empty in the actual configHere is what I am entering in the config modeevent manager applet bgp_detectevent syslog patt...
I would like to have eem applet to run say hourly and copy file ( something like below ),
I believe i may have an issue after action 1.0 as it results in the next line
as it would confirm destination file name and i would assume expect the enter po...
Here is a sample scriptevent manager applet test event routing network X.X.X.X/X protocol BGP action 1.0 syslog msg "Route $_routing_network $_routing_protocol $_routing_type $_routing_lastinterface" action 2.0 mail server "$_email_server" to "$_emai...
Does any one know of a way to monitor changes in bgp routes received from remote routers. I am curios if theis could be done with EEM or something using just available technologies on the router ?Thanks in advance
Is there anything special that needs to be added in terms of NAT or similar ( same interface statements ) to allow the packet destined to the internet through tunnel . In my testing and packet tracer shows drop as a result.
I am new to Meraki as well , however pretty much everything in Meraki is controlled in dashboard.For every type of equipment there are updates that are applied automatically depending on whether you choosemore stable or beta type software. You can sc...
Thanks Joe,
How do i get by the confirmation prompt for copy
copy flash:dhcp.db stby-flash:dhcp.db Destination filename [dhcp.db]? Copy in progress...C7181 bytes copied in 0.120 secs (59842 bytes/sec)
I don't believe
action 1.0 cli command "copy fla...
