Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I' m going to add a new 3750X Switch to an existing stack. The existing stack is build of two 3750X switchs with different feature sets:
show switch detail
*1 Master xxxx.xxxx.xxxx 15 3 Ready ==> Iicense level ipservices WS-C3750X-12S-E 2 Member ...
Hi folks!We have two different locations:Location A: ISP 111.111.111.111 with cisco WLC infrastructure and a normal LAN/WLAN network xxx.xxx.xxx.xxxLocation B: ISP 222.222.222.222 with a office extended access point (CAP2702) The office extended acce...
Hi there! The Cisco AIR-ANT2524V4C-R antenna comes with a standard 3 ft (91.4 cm) plenum rated, UV stable cable. Is there a possibility to extend this cables?We have a building there is no room to place the accesspoint near the external antenna.But t...
Hi there.We have a bunch of CAP 2702E access-points in combination with the AIR-ANT2524V4C-R external Antenna and WLC 2504In the instructions I found the flowing sentence: <<The 5-GHz antenna cables are identified by a orange collar nearthe connector...
HiFollowing problem: I configured VRF-lite on Catalyst 3750x. Its working fine but now i have a strange behavior. If a Device, who is connected to the switch has to be replaced and the new device has the same fix IP address as the old one, the device...
Thank you Scott. It was like you said.The TX of the internal antennas was set "1" and near all external had "6" by global assignment. I made some measurements and had in one room first -83dBm with TX6 andlater -65dBm with TX1. Massive!
Thank you Scott for the fast replay.The Problem is that we have a small range of signal. And it seems that something isn't correct here with this installation. The antennas are all ceiling mounted.The only thing configured is the Antenna Gain in the ...
