Folks, what are the steps/commands to configure a port-channel between 2 Nexus 3000 switchs and then to configure multicast so it  can travel thru the channel? Thank you in advance n

This might be a very simple question, but what is the correct configuration settings when you want to create an ether-channel using 2 ports on the same Nexus switch to a Esxi host? Do you need to specify the "vpc" command within the interface port-c...

How do you measure the current throughput on a Cisco 2811 router?We will be replacing this unit with a 4000 series one but the new devices limit the amount of throughput and require a license to increase the limit.Also, anyone aware of the commands t...

Quick questions folks, we have a Cisco 2811 running for the past 8-9 years non-stop.We now have purchased one Cisco 4321 and we are looking to replace the 2811 with this new 4321 router.What is your advise on this? Being that these 4000 series are so...

Can the 2504 be deployed in such a way that it will have an SSID and have each WiFi client connect to the Access Points with their own username and password credentials? These credentials are to be kept locally on the controller.I believe this is pos...