Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Here is another trick.Using the telnet to Router A and then telnet to Router B, from A example.On Router B, you can set the 'escape' character. The default being '6' for both routers.Here we are stetting the escape character on Router B to the 23rd l...
FYI I had a site to site tunnel that would not come up on Phase 1 with the following debug warning: deleting SA reason "Recevied fatal informational" stateDevice: VPN Service Module blade199.173.227.18 149.168.1.164 MM_NO_STATE 78536 A...
Bel, So you added both an inbound and outbound rule for udp 443 on the 'outside' firewall. Not until I added the UDP rule did the Anyconnect client connect with DTLS. You can verify how the AnyConnect user is connecting to the firewall using ASDM,...
Success The SSL AnyConnect client is not the limiting factor (given a fairly new PC running Win 7), circuit speed and the communication protocol (TLS vs DTLS) are. Since the target SSL firewall sits behind an 'outside' firewall I had to add both an...
