Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently use a CISCO2921/K9 router to connect to my ISP for Internet service. I am replacing that with an ISR4451-X ISP hands off using Local Access Native Single CoS Medium Ethernet. I basically just copied the 2921 config to the 4451. From the 2...
Is it possible for Cisco Jabber, using computer for calls, to provide a dial tone before a user dials a number.
My user is using a wireless headset that connects to PC with USB dongle. Headset provides a setting to allow for dial tone from soft pho...
I recently configured the FREE version of the Threat Awareness Service. Got it all configured and was seeing data being populated in SNTC in my Threat Awareness section. Everything was fine for about a week or so. Now all I see is a blank page under...
I currently have Jabber for Windows 11.5 deployed in my on-premise environment. I've noticed this same issue on previous versions as well.
The issue I am having is when a user shares their screen with me. There is a bar at the top of the window that...
I'm trying to edit the CFUR destination for each 4 digit DN to the DNs full 7 digit DID number so when I have a WAN failure, calls will route out Local Gateways through the PSTN. I can edit them each manually (which honestly I'd be done with by now),...
I had the same issue with a version of CUCM that was in the list of known fixed releases. Applied the cli sql command to enable SSO and it's working. Thanks for this post!
Yeah, I was wondering if I had the right part, but it just isn't working like it's supposed to. I do have the 8832-POE and it is only providing POE from the switch port, no network connectivity for some reason. Thanks!
