Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a nexus 7018 with FIPS enabled, and now when I insert an M108X2 line card in slot 4 it won't power up, and I see this in the logs:
%SECURITYD-2-FIPS_POST_ERROR_MSG: LC 4 failed (pre post failure)
What does it take to get that line card to po...
I see these ports open when running nmap against IOS switches: 22, 902, 903, 3389, 5900, 5906. These were just form 3750's running 12.2(35)SE2 and 6900's running 12.2(33)SXH2a. I would have expected ports other than 22 to respond, and some boilerpl...
This question arises from a UCI environment in our datacenter where I'm trying to track down a fragmentation question. We have 7018 switches with Fabric Interconnects 6296 used to connect to ESX hosts. The interfaces on the 7018 have an MTU of 9216...
I have two access layer switches sharing a dot1q trunk ( a port channel with four members), and an HP blade server with one connection (a port channel with two members) into each.. The blade server's connections into each switch is also a dot1q trun...
I'v seen this on 3750's and 6500's. the 3750s are running 12.2(35)SE2, and the 6500s are running 12.2(33)SXH2a. "no snmp-server community public" was issued on both, with no effect. Here's what happens:$ snmpget -v 2c -c public switch 1.3.6.1.2.1....
So the MTU setting on the interfaces themselves (the "MTU" parameter seen int the output of the "show interface" command) can be below the QoS setting, and the interface will still take frames larger than that MTU see in the 'show output' command? th...
So if I understand correctly, if I have:
and I see:
FICUCI011-A(nxos)# sho queuing int eth2/3
Ethernet2/3 queuing information:
TX Queuing
qos-group sched-type oper-bandwidth
0 WRR 60
1 WRR ...
Here is a basic pic of how this blade server is connected to the two switches (nexus 7018s): The question in my mind is if the commands to see the mac table of each respective port channel on each respective switch are issued within one - five tenths...
Can't show the config (company policy - even sanitized is probably not allowed) and can't shutdown snmp, other than that there is a readonly non-public string and a readwrite non-private string. I tried "no snmp-server community public", but that di...
