Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I just pulled from production an old C1921-k9 which onorably served for 14 years as main router terminating a PPPoE FTTC connection providing VPN services for a SOHO network. Now with FTTH the router has reached its limit and been upg...
Good evening,I just took delivery of a new C1161 (in the OP was wrongfully indicated as 1611 this note is here to explain the misunderstanding below) which is a router + 8 port switch. I am a bit stumped about the switch performance: I cannot find an...
Good morning everybody and thank you for your time in reading the following.I am in the process of deploying a couple of C1300-8MGP-2X (named MGP1 and MGP2) which do not use Catalyst OS but something different (hence the struggle). These are currentl...
Dear All,I bought 2 Cisco C1300-8MGP-2x for my home network since I have plurigigabit optical connectivity to the Internet.I was kind of expecting to find the usual Catalyst os and command. Cisco made a very bad (in my view) choice to keep teh cataly...
Hello everybody,I am in the process of deploying a C1161X-8P. The router has 2WAN ports, 8 LAN (layer2) ports of which 2 can be reconfigured as Layer 3 (wan?) reference:Cisco 1000 Series Software Configuration Guide, Cisco IOS XE 17 - Configuring Eth...
@andrew.butterworth wrote:The switchports (GigE0/1/0 - 7) don't accept the 'channel-group' commands.I am a bit late to the party, but I was looking into port aggregation on the ISR 1100 family and I wish to contribute what I found out, because this p...
Good morning every one,As I said the issue here was that the Card was intended for North America and non Europe, therefore the lack of signal was due to the fact there was no NorthAmerican frequencies coverage in Italy ... Duh! Acquired a global card...
Hello Giuseppe, thanks for your reply. The router has coverage other devices with internal antennas works with 4/5 bars of service. And yes there is a working SIM card in the EHWIC which communicates with the EHWIC (unlock and PIN change).I am afraid...
Flavio, thanks again. That is the document I studied. I will re-read an experiment more with the config. But!What I am wondering is if I should see indication of presence of signal no matter what (since signal is there for the carrier of the inserted...
Hello Flavio and Thanks.Yer the router wa also moved from intended location to an open location in order to ensure was in good coverage. A small 4g/wifi router with a sim of same carrier and an iphone connect to the network with 4/5 bars.Signal is th...