Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In Cisco ccw after selecting C3925-CME-SRST/K9 it automatically include 25 srst license.Then is possible to choose fl-cme or fl-srst.What is the difference considering that in both cases 25 srst license are included?Thanks
Dear All,i need to connect via 100BASE-X uplinks some access switches to 6509e VSS distribution Switches having SUP-2T.It seems that the only module on 6509e supporting 100BASE-X SFP is WS-X6148-FE-SFP. This module is going EoS and is not supportes i...
Dears,i would like to allow multicast traffic to flow between different vlan in an HSRP environment.Here attached the network drawing.In the attached example multicast traffic is required between hosts in vlan 10 and vlan 20.Is HSRP aware PIM what i ...
Dears,in the attached picture i drawn two possible scenario for RSPAN.In the first scenario there is only a Source Switch (A) and Destination Switch (B). Is the full configuration correct?In the second scenario i added an Intermediate Switch (C) betw...
If the client would like to add same cucme in different locations in srst is it enough to by the required srst licenses in each location based on the number of phones in each location?Are there any licensing differences if the cucme are configured in...
In my previous drawing I wrote in red the PIM configuration. Is the configuration of the rendezvous point with loopback0 on core A correct?Moreover In blue the PIM commands related to HSRP. Are they mandatory in such environment?Thanks
I have open the configuration of WLC obtained as follow:1) WLC: Commands > Upload Files2) WCS: Administration > Background Tasks > Controller Configuration BackupAnd in both files there is no AP configurati...
Becouse my client i asking to provide the APs' documentation.I'm thinking to provide the full WLC configuration (show run-conf).There is a way to make " copy running-config tftp" in WLC ?Or you suggest a better way?Thanks
